Spray lining first for Scottish Water boosts chamber integrity

Spray lining first for Scottish Water boosts chamber integrity



Spray lining first for Scottish Water boosts chamber integrity
Earlier than (left) and after (proper) photographs of the chambers at Decrease Largo (picture credit score: Lanes Group).

Wastewater upkeep and restore specialist Lanes Group has carried out the primary spray lining challenge commissioned by Scottish Water to rehabilitate chambers serving a big moist effectively.

The revolutionary challenge has efficiently strengthened the 2 chambers on the outfall of the moist effectively at Decrease Largo, Fife, stopping the property from having to be excavated and changed.

Lanes Group, which is a framework provider for Scottish Water throughout the entire of Scotland, prompt the answer after it was discovered that the chambers wanted to be sealed and strengthened.

The corporate carried out the work for Morrison Development, a framework contractor delivering design, engineering and development providers for Scottish Water.

Matthew Anderson, Connection Supervisor at Morrison Development, mentioned: “We’d prefer to thank Lanes Group for making use of the revolutionary Hermes M-Coating system, together with ERGELIT dry mortars to those very deep chambers.

“They’d been badly affected by hydrogen sulphide corrosion. The spray lining work saved us from having to put in momentary works in extra of six metres deep to exchange the asset. The carbon financial savings alone had been enormous.”

David Beveridge, Regional Gross sales Supervisor for Lanes Group, mentioned: “Except an acceptable no-dig rehabilitation resolution was discovered, the one choice was to think about changing the chambers.

“This could have been a serious engineering activity, carried out over many weeks, with important mitigation in place to make sure continuity of wastewater providers for wastewater prospects.

“The answer Lanes offered, as a substitute, was accomplished over six days, with all required outputs achieved. This was each extremely cost-effective and very sustainable, with no inconvenience for purchasers.”

The spray lining was carried out by Lanes Group Sewer Renovation.

One of many chambers was fashioned from concrete rings and was 6m deep and 1.2m in diameter. The opposite was a brick-lined sq. chamber that was 6m deep and 2m extensive.

Every chamber was first cleaned by a remotely-controlled excessive strain water jetting system. Mortar was then injected into the joints of the concrete ring chamber to seal them.

In a remaining course of, one other remotely-controlled rig was lowered into the chamber to spray-line its partitions with a specialist dry mortar.

The pc-controlled system robotically accomplished 50 coats of every chamber to create a liner 10 millimetres thick, with the coating cured in 24 hours.

Lanes Group Sewer Renovation Technical Supervisor Gary Carey mentioned: “The material of the chambers had been broken by various contaminants, together with raised ranges of hydrogen sulphide.

“The mortar we utilized is resistant to those chemical compounds and creates a sealed drainage system with the required structural power and long-term safety in opposition to water infiltration and leakage.”

Spray lining wastewater property is a way more sustainable than excavation and alternative, offering an answer with a smaller carbon footprint.

Normally, additionally it is a lot faster, safer and simpler to hold out, utilizing much less gear and supplies and extra restricted confined house entry.

Gary Carey defined: “On this occasion, the moist effectively chambers had been situated simply off a single-track rural highway however had been straightforward to entry by the small Lanes Group spray lining workforce.

“Had the chambers wanted to get replaced, the identical wouldn’t be the case for an excavation workforce with the vary of plant and supplies they must deploy.”

www.lanesdrainageservices.co.uk

Leave a Reply

Your email address will not be published. Required fields are marked *